3D Systems CUBEX Podręcznik Użytkownika Pobierz pdf (Strona 18)

Before you attempt to remove your creation from the Print Pad, please ensure that the CubeX has nished printing

and that the Print Pad has moved to the bottom of the CubeX.

REMOVING YOUR CREATION FROM THE PRINT PAD

FINISHING YOUR CREATION

1. Remove the Print Pad from the CubeX.

2. Submerge Print Pad and the base of the part in warm water for ve minutes.

• If you do not have the ability to submerge the Print Pad place Print Pad in sink and let hot water run over the base

of the part for about 5 minutes

3. Use the scraper (included), gently release your creation from the glass.

4. Rinse your creation under hot water to ensure all of the CubeStick paste has been removed.

5. To clean the Print Pad, rinse the pad under hot water to clean off any remaining CubeStick paste. Allow it to dry before

your next print.

6. Dry the Print Pad thoroughly before reinstalling it in CubeX.

REMOVING RAFTS

Though we recommend printing without a raft, some larger or more complicated parts may require one. If you print with a

raft, the following instructions will help you remove it:

ABS RAFT / PLA PART - PLA RAFT / ABS PART ABS rafts can be peeled away from PLA parts.

ABS RAFT / ABS PART - PLA RAFT / PLA PART Use pliers to pull away as much of the raft as possible. Then use a

rough-grade sandpaper to remove the remaining raft, followed by a

ne-grade wet and dry sandpaper to achieve a smoother nish.

REMOVING SUPPORTS WITH WIRE CUTTERS

Use wire cutters to cut away the support structure from your model. You should cut the supports at the point where they

touch the model.

• Turn the CubeStick upside down so the glue ows to the tip. (Fig. 60)

• Apply 3 layers of CubeStick using a slow circular motion. (Fig. 61)

3. Select the ‘Print’ option from the main menu.

4. Using the arrows at the bottom of the screen, scroll to the .cubex les you wish to print and tap on the le name. (Fig.

62)

5. Your CubeX will now start printing your creation.

Fig. 60 Fig. 61 Fig. 62

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Brak uwag

3D Systems CUBEX Podręcznik Użytkownika Strona 18